There are two reasons you might be reading this; either you’re currently sitting over a ruined stitch, or you’ve made a few too many mistakes in the past. The good news is at some point everyone has made the same mistake, so don’t fret!
First things first
Take a breather. If you’ve just noticed your mistake, don’t fear there is ALWAYS a way out. So let’s get into the list:
Knots on the back
I should state now, you need a smaller bit of thread. As standard, you should look for about a lower arm’s length.
If you have a small knot pull on the knot and pull towards to hoop. Then pull all the following threads tight like a shoelace.
If the knot is big (or there’s no hoop) then this won’t do. Instead, start chopping. Make sure to only cut threads involved in the knot and leave as much “free” thread as possible. Once the knot is gone and you have a series of loose strands, start stitching the surrounding area, and stitch over the loose threads. By the time you’ve finished the surrounding areas, the threads will be all stitched up. Alternatively, you can push the loose threads under the backs of the stitches like you would end a thread.
You’ve spilt something on it
Yeh, normally tea, right? Well this is super simple, just wash it. However, as you haven’t yet finished, make sure you don’t iron it.
This happens a lot. I don’t know of anyone that hasn’t managed to do it. You should really look into future ways to avoid this, like thread breaking, and fabric pens, however, you have two possible solutions.
Let’s say we have a missing stitch marked on our Pikachu performing iron tail, with a blue blob.
You could then think about removing the lines from that point on towards the end of the piece, marked with dark blue lines.
This means you have to be prepared to edit your pattern in a big way, but sometimes is the only way to get it to work. The Pikachu still looks fine:
Depending on the stitch in question, it might not matter a whole lot, much like the Pikachu pattern, you could easily fill it with yellow and no one would ever know.
Well, sometimes that’s the easiest way…
Wrong stitch placement
The whiteout technique about might be a good idea here, however, for the most part, you probably want to unpick what you have. But let’s say its a massive area, its obvious and you can’t do a whiteout. Cut it out.
Now, this seems harsh, but if you cut out the offending area, and stitch a new small piece of aida on top it’ll be totally hidden by the time you finish. Easy!
Know of any other stitching disasters? Throw me a line and I’ll help!