Title: 3D Printed Cross Stitch Ring
Date Completed: December 2018
Design: Lord Libidan
Count: 14
Canvas: 3D printed ring
Colors: 1
Size: US 8 (UK P)
 
For my last cross stitch of 2018, I knew I wanted to do something small, but as it happens, I was FINALLY able to complete a project I’d been working on for the last 5 years.
nbsp;
I’d always loved the idea of 3D printing, and I think many of my 3D cross stitches, such as my Transforming cross stitch were routed in, however, I recently got the ability to print accurately on a 3D printer in high detail. I used this excuse to pull a simple ring design, and then edited it to work with a line of cross stitch, in 14 count.
nbsp;
In order to do this, I had to pull a small interior ring to hold the back of the threads (so they don’t stick into your finger) and align the holes in a specific orientation to ensure the needle would fit through. You can see these changes in the below image a bit clearer.

However, the hard work didn’t finish there. I had originally made two ring ideas, one with a 18 count, and one with 14. Whilst I was able to stitch both, the 18 count one simply didn’t work (the holes were too big). This, however, wasn’t something I count fix. The size of the holes needed to be large enough that the smallest needles I could find (size 10 sharps) would fit through using a sewing thread (not embroidery).
However, all that work done, it was a simple case of stitching it up, and wearing it. I might actually offer a limited run of these on my Etsy if anyone is interested…